Grasshopper

algorithmic modeling for Rhino

extend / trim curves

i have some curves within another one ('border') and want them to end at the 'border'.

i extended and trimmed them. how to delete the outer leftovers?

or is there a direct way to extend curves just until this border curve?

Views: 8898

Replies to This Discussion

Permalink Reply by Chris Tietjen on July 24, 2011 at 9:39am
Chris
Permalink Reply by mxmln on July 24, 2011 at 11:57am
thats how i set it up, but the cut off curves still remain visible. is there a possibility to discard/delete that data? or is this just done withe the 'preview' function?
Permalink Reply by David Rutten on July 24, 2011 at 12:06pm
It's never possible to delete existing data. All you can do is create a new list of items that doesn't include the ones you don't want. If you don't want to see certain curves, you'll need to switch off the preview for those components/parameters that contain those curves.

--
David Rutten
david@mcneel.com
Poprad, Slovakia
Permalink Reply by alparslan zafar on March 31, 2016 at 3:12pm

İs it possible to do that without a closed boundary curve and without any region?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service