algorithmic modeling for Rhino
Extract List-Data
Hallo dear all,
I creat a station-roof as foto below.
As you see on the edge of roof there are a top chord which above the bottom chord.
Now I try to creat web member between top and bottom chord.
Generelly I can connect the the points along the both chords in oder to made lines as web member.
I take the 2 curves(top and bottom chord) and divide it into the same number(green points).
Now we can see the problem, that the green points dosent match the red points. Coz the red points are made through ''Divide Domain'' and the green points are divided through 'divide curve'.
How it is possible to 'extract' the List-Data(as List A) from the divided-Domain, so that we could put (using 'Crv CP') those Data on the bottom chord (as List B)...please look sketch below.
thank u all!!
Views: 1678
Replies to This Discussion
-
Permalink Reply by taka on
-
something like this?
- Attachments:
-
-
Roof_revised.ghx, 382 KB
-
-
-
-
yeah for those formulas, I just had to find the rules of how the points were indicated.
For this one, you can use <sub list> component followed by your list of points and <domain> component which has (10 to 16) as domain.
you'll find <sub list> under (sets>list>sub list) and <domain> is under (params>primitive>domain)
Good luck!
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Scaling Tower
Added by Parametric House 0 Comments 0 Likes
-
Field Trap
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
