Grasshopper

algorithmic modeling for Rhino

I have a problem to create a sweep2 surface from 2 rail and 4 section curves in grasshopper.

What is strange, that I was able to generate the sweep2 surface in Rhino  by exporting the curves. 

I have tried to change the curve directions, to make the same datastructure, but these did not help.

Could anibody explain what is wrong, and how to solve it in grasshopper please?

Views: 297

Attachments:

Replies to This Discussion

Hi Ferenc,

The order of the curves is bad.

Hi Rémy,

Thank you for taking your time for the answer! 

The order I have used was 1,3,2,4 (counterclockwise).

I did not imagined that I have to follow the clockwise order, 1,4,2,3.

This works, my problem is solved.

Thanks again!

Ferenc

Ferenc,

little precision:

you must follow same order for a rail curve !

Best,

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service