Grasshopper

algorithmic modeling for Rhino

Variable Piping not working as intended

I have a rectangle whose boundaries I'd like to pipe using variable piping. 

When I plug in 1, 2 or 3 sides, the piping functions normally.

However once I plug in the fourth, there is an error.

PFA the error.

Views: 315

Attachments:

Replies to This Discussion

Permalink Reply by Daniel González Abalde on October 29, 2015 at 8:55am

Do Graft on the Crv component (via right click) or join all lines.

Permalink Reply by Shounak Bhattacharyya on October 29, 2015 at 9:25am

Grafting worked fine.

Thank you.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service