Drawing polylines diagonally

Replies to This Discussion

Permalink Reply by David Rutten on September 20, 2015 at 3:34am

You can use the [Relative Item] component with the proper offset notation. To see what the proper notation is I'll need to know what your datatree of points looks like. Either upload that part of the file or post a screenshot of a Param Viewer hooked up to the points.

Permalink Reply by Chen Siran Maxie on September 21, 2015 at 1:49am

Thank you very much. I solved the problem with relative item.

Permalink Reply by David Rutten on September 21, 2015 at 4:27am

Usually both outputs are used (see attached), but it works your way as well.

Attachments:

• relitem.gh, 9 KB

Permalink Reply by Chen Siran Maxie on September 21, 2015 at 7:21am

Thank you very much. May i ask if i can possible fin the intersection point as well? Mine seem only showing the end points.