Lofting problem

Replies to This Discussion

Permalink Reply by Joseph Oster on August 4, 2015 at 9:37am

Code please?  With 'Internalized data' for surfaces and curves.

There is ABSOLUTELY NO WAY I'm going to wire that up based on a screen shot, just to try and help someone...  Without your curves and surfaces, it would be a waste of time anyway.

Permalink Reply by aim on August 4, 2015 at 11:59pm

Hello Joseph,

For some reason it wasn't uploading my files at that time. Here you go.

Thanks..

Permalink Reply by aim on August 5, 2015 at 12:25am

Attached

Attachments:

• lofting.3dm, 2.4 MB
• Lofting_Problem.gh, 15 KB

Permalink Reply by Hyungsoo Kim on August 5, 2015 at 2:37am

Hi.

You should check and adjust curve seams and directions first and the same about the  list order of your two pair of lofting curves.

I've internalised fixed surface and curve data, so you don't have to use your original rhino file.

Attachments:

• Lofting_Problem_re.gh, 30 KB

Permalink Reply by aim on August 5, 2015 at 3:38am

Hello Hyungsoo,

Thanks for the help. Is it possible to place a slider where you can control each loft opening with a random angle so the openings move left to right/ up/down?

Thanks..

Permalink Reply by Hyungsoo Kim on August 5, 2015 at 9:55am

Have a look at this new one. cheers.

Attachments:

• SurfaceDiv_&_Extrusion.gh, 18 KB

Permalink Reply by aim on August 6, 2015 at 8:40am

Thanks!