Grasshopper

algorithmic modeling for Rhino

Having trouble understanding intersections

Hi,

If I want to delete overlapping curves from something like the cells of a voronoi, how would I go about that?  I want to start by shattering the cells...but I'm not sure I understand the shatter component.  And then ...would I use the line|line component?

Sorry, a little lost here.  My goal would be to just have single lines everywhere, no overlaps.

Views: 208

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Nik Willmore on July 30, 2015 at 8:05pm

I just did that here:

http://www.grasshopper3d.com/forum/topics/idea-with-bone?commentId=...

I did have to flatten the remove duplicate lines input and set a loose tolerance by right clicking and entering a number like 0.001 I think.

Permalink Reply by Mike on July 31, 2015 at 7:25am

Thanks for the tip!  Ugh, I haven't even seen most of those components before...so much to learn :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service