Grasshopper

algorithmic modeling for Rhino

Negative decimal converting to positive at point construct

     I am sure that I am not understanding something very simple with this issue.  I am hoping to keep negative number conversions to a minimum and have been struggling with the output of my [negative z coordinate slider] converting to a positive coordinate at the [point construct module] output. The bottom panels trace to the issue.

Any advice is appreciated. 

-Mike

Views: 924

Replies to This Discussion

Permalink Reply by ng5 Alex on July 25, 2015 at 2:43pm

Hello Mike,

you giving to z input of right construct point component, the Pt output of the left construct point component. the z input expects a value, instead you are providing a point (x,y,z values). why not use the slider directly?

cheers

alex

Permalink Reply by Mike Fleck on July 25, 2015 at 2:55pm

Thanks that works. It was incorrect for me to feed into a point construct then into another point construct.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service