Grasshopper

algorithmic modeling for Rhino

Saving selected piece of geometry to file, c#

I've been trying to use the File3dm methods to save an instance of rhino geometry to a 3dm file. 

I haven't had luck writing code that can connect the instance (ie. a grasshopper brep) to its original rhino brep.  Can someone please direct me to the methods are out there that will enable this?  I've looked at rhino commmon but haven't been lucky in finding the right method.

Views: 3038

Replies to This Discussion

Permalink Reply by David Rutten on June 2, 2015 at 8:11am
GH_Goo is an abstract base class that implements the IGH_Goo interface. A lot of data is derived from GH_Goo.

Save how? Just write the bytes to a file? Create a 3dm file? Create a gh file?
Permalink Reply by Starsk Lara on June 2, 2015 at 8:33am

I want to save the geometry in *3dm file. i was reading your script collectandexport.gh,. but the geometric can no be internalized in grasshopper.

 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service