Grasshopper

algorithmic modeling for Rhino

smoothing nodes

Hi all,

 

I need help smoothing a big amount of nodes like this one.(4 and 5 directions..) I want just one single smooth surface. (All at once, not modelling with tsplines one by one..)

 

I tried to convert it into one single mesh and then use weaverbird but its difficult. ( spheres, booleans etc..)

 

I think this is the key point. Convert this pipes into meshes and then merge them withweaverbird or tsplines. The problem are the booleans..

 

Any idea?

 

Cheers!!

Views: 25027

Replies to This Discussion

Permalink Reply by Kim hauer on May 21, 2015 at 9:23am

I had not forgotten about the Glass/Weatherstripping, and the pain of replacing a broken pane. :)  After the Dome is constructed the Glass or acrylic panes would rest on top of the Universal joint with an H shaped gasket (glass to glass) and a Universal cover screwed thought the Universal joint holding the panes in place.

Its now no longer your average backyard Playdome :)

Permalink Reply by Jacek Jaskólski on May 22, 2015 at 7:04am

Hi Martyn,

It wasn't a nightmare, but neither was it a breeze ;-)

Here's the timelapse:

https://vimeo.com/41314204

3D printing made sense in our case because each node was unique.

In your case some kind of mould seems much more adequate.

Permalink Reply by martyn hogg on May 22, 2015 at 1:37pm

That's awesome! Looks pretty solid too!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service