algorithmic modeling for Rhino
hello to everybody,
I will ask you how I can made a surface between curves in my project.
I tried different methods, for example I used the addon minimal surface loft,without progress.
I hope that you can help me
Tags:
Hi gasterx,
Where can I get or download this addon?
http://www.cerver.org/downloads/
BTW: I would rather suggest to dig-in into Kangaroo as well for that min surf matter. Notify if you need some "simple" (*) examples that use both ways.
(*) kinda, he he.
best, Peter
BTW: Plan B: minsurf VS Kangaroo. See 212_xxx attached (very old case that one almost prehistoric, I don't use GH components any more these days)
BTW: Plan C: you can use Starling as well (not apples to apples VS Kangaroo, but good in quite a few cases). See MinSurf_xxx attached (use Rhino file if data internalization fails, happens in most of cases).
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by