Grasshopper

algorithmic modeling for Rhino

Creating a pentagon surface

Hi guys,

i wanted to achieve an openable panel in a curved srf like the air flower facade attached below. its a little different than that as i divided hexagonal patterns into 3 parts creating pentagons that opens up instead of 4 triangles. 

What i did

1. project hexagonal grids into a curved srf

2. make hex panels flat 

3. debrep to divide panels to 3

4. create lines to form a pentagon 

5. set rotation axis for its rotation

However, problem was i can't seem to make the pentagons into a surface.

tried capping and boundary srf but failed. 

Gh file attached below.

Views: 1757

Attachments:

Replies to This Discussion

Permalink Reply by nikos tzar on October 11, 2014 at 11:10am

Hello Kelvin,

The initial surface on your file is not internalised. Please do that and repost or upload your 3dm file as well.

Permalink Reply by nikos tzar on October 11, 2014 at 12:01pm

I gave it a try with a surface I created, if it doesn't work on your case then follow the suggestions above.

Attachments:
Permalink Reply by Kelvin Karel on October 11, 2014 at 11:22pm

yep ! that was what i was planning to achieve

Thank you !! appreciate it!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service