How to make a surface between 3 arcs

Replies to This Discussion

Permalink Reply by ng5 Alex on June 24, 2014 at 4:20pm

Hello

The loft fails for two reasons. First is that you don not have the same data structure between the arcs you are trying to loft. Also the arcs need to be organized in a list, since loft is a single input component, one list for each set of three arcs. please check foto.

the second problem was a small one. you need to have for all the arcs the same inputs. if punkt1 is the first input of the arcs, then all the arcs need their punkt1 in order to have same direction and so that you don't get misaligned, twisted loft.

hope that helps

cheers

alex

Attachments:

• Grasshopperneedhelpwitharc_1.gh, 75 KB

Permalink Reply by Nikoline Werngreen on June 24, 2014 at 4:37pm

Thank you very much for your help! now it all makes sense :-)

Tank you again for taking time to help me - i'm very grateful ! :-)

Best regards

Nikoline

Permalink Reply by ng5 Alex on June 24, 2014 at 4:47pm

:-)