Applying forces to multiple meshes at one go

Hey all,

I am trying to apply the same force to multiple meshes all using one kangaroo component. It works when I apply it to a single mesh. I am basically trying to create a controllable bubble like surface by applying UForce and SPRINGS.

Additional components I have used here were simple weaverbird and kangaroo.

I have tried flattening anchor points as well as forces but to no avail.

All help will be greatly appreciated.

Joel

Attachments:

Replies to This Discussion

Permalink Reply by dcjxb on March 11, 2014 at 7:06pm

I m not sure this is what you want？

Attachments:

QQ图片20140312085812.jpg, 44 KB
QQ图片20140312085836.jpg, 94 KB

Permalink Reply by Zhou Joel Wong on March 11, 2014 at 9:53pm

Thank you so much, that was what i wanted. I tried following the one on the image but it still doesnt work. Could you upload the definition instead? Thank you so much.

Permalink Reply by Zhou Joel Wong on March 11, 2014 at 10:47pm

Hi dcjxb,

I managed to solve the problem, something was up with my initial Brep

Thanks for your time

Permalink Reply by dcjxb on March 12, 2014 at 3:39am

I think it is some of the initial brep too small,so the length of mesh edge is less than 0.01.I scaled the brep 5 times ,so it works

Attachments: