Grasshopper

algorithmic modeling for Rhino

Tensile srf using the kangaroo 2

this link 

→http://www.grasshopper3d.com/forum/topics/tensile-srf-using-the-kan...

I'm trying to tensile structures.

When I was going to make a different thing,an error has been given

I want to move circle more than two to the different vector

However, an error happened

Would you help me once again?

Views: 2506

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on September 26, 2016 at 12:10pm

Hey.

You don’t seem to have much understanding of the previous definition yet.

The key point is separating anchor points group during the simulation.

And I think your initial mesh quality is not so good, ..Try "Mesh Machine".

Attachments:
Permalink Reply by Y.Kate on September 26, 2016 at 2:02pm

Thank you very much,

 

Thanks again!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service