Grasshopper

algorithmic modeling for Rhino

stop or pause processing on Grasshopper

Hello,

 

I´m doing a generative processing and it from 1 to infinite (going through Series function). It process every int in the list and takes few seconds per int.

Grasshopper is now hanged in the infinite process. I can only stop finnishing it in the task manager of windows.

Is it possible to stop/pause/play the processing?

 

Thanks in advance

 

Views: 2414

Replies to This Discussion

Permalink Reply by David Rutten on September 2, 2010 at 11:58am
Unless you have the very latest version of Grasshopper you cannot escape a solution.
Grasshopper 0.7.0049 has Escape detection build in, meaning that the state of the Escape key is tested between every solver iteration (i.e. between components and also between different iterations in a single component). It is still however possible that a custom script locks up the solution indefinitely.

--
David Rutten
david@mcneel.com
Poprad, Slovakia
Permalink Reply by GHtwim on September 2, 2010 at 3:41pm
The lastest version of Grasshopper in the download page is 0.6.0059.
Where can be downloaded 0.7.0049?
Thanks David.
Permalink Reply by David Rutten on September 2, 2010 at 3:47pm
http://www.grasshopper3d.com/forum/topics/grasshopper-070049-available

--
David Rutten
david@mcneel.com
Poprad, Slovakia

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service