Grasshopper

algorithmic modeling for Rhino

offset help

Hello,

 

I have projected curves onto a surface and when I offset them, some curves offset inward and some outward....I baked them to see their direction, but they appear to have the same direction. Anyone knows why?

 

Thanks!

Views: 863

Replies to This Discussion

Permalink Reply by David Rutten on April 8, 2011 at 2:52pm

Hi TC,

 

there's a serious bug in the Offset component. Well, there's at least one serious bug in the offset component, I suspect there are more. But I only found one recently. It's fixed, but won't be available until the next Grasshopper is released. I was hoping to do that today, but there was a lot more work than I predicted.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service