EVALUATE CURVE INACCURACY?

Replies to This Discussion

Permalink Reply by David Rutten on November 12, 2010 at 4:27pm

Hi idtasos,

curve parameters do not have a guaranteed linear progression along the curve. Lines, Arc and Circles typically do, but Nurbs curves or polylines do not. You can see this by feeding a Range component into the Eval curve component and create -say- 100 points with equal parameter spacing.

If you want to evaluate based on length then you should use the [Evaluate Length] component.

--
David Rutten
david@mcneel.com
Seattle, WA

Permalink Reply by idtasos on November 12, 2010 at 4:31pm

thanks, i will try the evaluate length component.