Grasshopper

algorithmic modeling for Rhino

Cap on non planar loft

Hi everyone! 

I have a quick question, is there any way that I could cap a lofted surface which is not planar? I made it from a polyline with (0,0,0) which is why I think the cap component isn't working, can anybody tell me if there is another way of doing this? 

Thanks so much! 

Views: 3338

Replies to This Discussion

Permalink Reply by Thomas J. Mrokon on October 1, 2012 at 12:55am

you can split (shatter) the closed curve into two similar parts (without undercut) and loft them...

Permalink Reply by TheChosenOne on October 12, 2012 at 1:50am

Attachments:
Permalink Reply by TheChosenOne on October 12, 2012 at 2:19am

Attachments:
Permalink Reply by TheChosenOne on October 12, 2012 at 2:34am

Attachments:
Permalink Reply by babym on October 12, 2012 at 9:02am

Thank you so much!! This really helps!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service