algorithmic modeling for Rhino
USING THE GRASSHOPPER FOR THE FIRST TIME AFTER DOWNLOADING THE SCRIPT. Ran the command "Grasshopper open" in rhino and then opened the open source script..But I get 10 errors titled "Component Exception"..I am a beginner with grasshopper and trying to find my way around it..any help appreciated
Tags:
Hi Jose,
this is a bug in the software, the error should be displayed transiently rather than with a modal window you have to manually close. I'll try and find the bug, but if I can't you may have to send me the file that is causing these errors.
--
David Rutten
david@mcneel.com
Hello David,
I have attached the grasshopper script which gives the error message...
I tried to find some kind of document which would help me get around the initial set-up...What i mean is this...in this youtube tutorial [Link below] gerard peterson demos the grasshopper module ..however, he is already inside the Rhino Module...Is there any documents which provides instructions on how to get to that stage ??
: https://www.youtube.com/watch?v=g4G6Wse4aKM
Thanks a lot in advance David,
Jose
You attached a bunch of images to the initial post, but no GH file I can open.
I'm not clear on what you mean by:
"in this youtube tutorial [Link below] gerard peterson demos the grasshopper module ..however, he is already inside the Rhino Module...Is there any documents which provides instructions on how to get to that stage ??"
You're clearly able to make screenshots of Grasshopper already, so you must have gotten this far on your own.
--
David Rutten
david@mcneel.co
I am sorry..Please find the attached script.
I would be immensely grateful if you can upload a similar script without a bug.
Thanks Again
hello.
this definition contains old components, it was composed with an earier version of grasshopper.
in these cases you go to the solution tab and select upgrade components, so grasshopper updates the old ones with the newer.
after that all these red components giving the errors just need to be replaced manually. they are the nurbs curve component. just make sure the new ones have the same d input (curve degree) as the old ones.
after that defiinition works.
cheers
alex
hello alex,
thanks a lot for the reply...It works now and parametric hull modelling has started..just wonderful..
I have asked this question earlier, but do you know of anyone who has used the parametric modelling capabilities to do some design optimization by linking grasshopper/rhinoceros to other optimization software ?
thanks a lot ,
Jose
hello Jose
i believe there must be someone in the forum but i don't know anyone to suggest.
in this post
http://www.grasshopper3d.com/forum/topics/grasshopper-070055-availa...
Steve Sanderson comments and shares a definition utilizing modefrontier.
perhaps its a good start.
cheers
alex
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by