Grasshopper

algorithmic modeling for Rhino

An experiment in layered plywood.

Views: 220

Comment

You need to be a member of Grasshopper to add comments!

Comment by martyn hogg on September 16, 2018 at 4:47pm

Well it's a stable door, as in it's going on an old horse stable which will be my workshop one day. Unstable because it has an oscillating pattern and when I shake the top, the whole thing wobbles probably because I used poor quality marine plywood instead of furniture grade plywood!

One of the biggest challenges has been that 18mm plywood is never 18mm! It varies from 17.8mm to 18.7mm across the sheet and averages at about 18.2mm so the heights of the hinges are out but i can use washers to pack the hinges to the right height. Unfortunately the right hand side is longer than the left so I might face some challenges getting it to fit but I can machine it to size hopefully.

As I said... it's been a bit of an experiment to see how this method of construction works out.

Comment by Laurent DELRIEU on September 14, 2018 at 1:13pm

It is very nice.

Why unstable ? 

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service