algorithmic modeling for Rhino

Views: 232


You need to be a member of Grasshopper to add comments!

Join Grasshopper

Comment by Maria Chiara Virgili on January 3, 2014 at 7:46am
thank you for your likes!!!
Comment by Maria Chiara Virgili on December 3, 2013 at 3:01pm
Yes it is! The algorihm is generated with kangaroo and millipede following the minimal paths theory of Otto Frei. Is quite complicated to explain, basically you need a circle and some crossing lines through it. The heart of the problem is in the setting of springs and forces to achive a good result of material thickening around your curves
Comment by Gui Talarico on December 3, 2013 at 1:58pm

Was this done entirely in Grasshopper? Could you share a few things about how you achieved it?





© 2020   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service