Chris,
Again the number of curves which SubCrv gives me is different from the actual curve on the surface! for example it gives me 80 curves in which there are 20 curves!
A low-resolution work. Real time motion capture display made with an 11x8 (88) pixels iPad matrix using Grasshopper + Firefly + Pure Data + TouchOSC for iPad.
a working solution with replacing this line of code with:
Dim charList As New List(Of Char)(charArr)
Is this because of a version incompatibility (I'm using Rhino 4.0, and GH 0.8.0062)? Just curious.
Regards,
JJ…
xtract A1, A2, B1, B2 as one set, A2, A3, B2, B3 as the second set, A3, A4, B3, B4...etc. as the third set and so on. How can I get about doing this?
Any help would be much appreciated!
Thanks,
Ben…
f the mesh was self-intersecting everywhere. So instead I used Millipede (isosurface) to get the same undulations, but ignore the complex 'folds', you can see the difference in cross section thickness. I then tessellated it with the inverse pattern of the outer surface.
To make it a single 3d printable mesh, i just deleted a single face on inner and outer skin, then lofted the naked edges. (creating a tiny hole through the model). Therefore creating a single mesh that folds in on itself, not sure if there is a better way of defining the space between two meshes as the solid area...
Full GH (Kangaroo - Meshmachine - Weaverbird - Millipede)
Special thanks to Laurent Delrieu for his interesting offset mesh method that i based my approach on.
http://www.grasshopper3d.com/forum/topics/offset-mesh-problems-with-3d-mesh-with-weaverbird…
Added by Nick Tyrer at 5:25am on December 10, 2015