re are two new lines inside the code that let you deal this issue. However, the results for that type of geometry will be something like this:
I think the issue is because of some curves in crvList.. and to solve it you have to play around the start number as Michael told you.
Anyway, If you want, you can try the attached file where there is a method which should be fine for both geometries in your file: with holes or not.
The principle is to set the first number of the series component to half of height of floor (e.g. floor = 3 meters => start = 1.5 meters) and you can create a piece of workflow to do this operation automatically.
Best
Antonello…
hing not acceptable. To build up the final results I tried to summarize some steps and script them but I got stuck.
1) Voronoi subdivision
2) Voronoi vertices connected to the center
3) Tween curves between center and boundary
4) Control of U and V parameters
Point 4 is really important because it will allow me to control the strength of the springs in the two directions in kangaroo. Voronoi curve is going to be an anchor and the point is going to pull the mesh.
…
mmed triangular NURBS surface. However, please notice that the parametrization will be small in the area of the two coincident vertices.
I'm attaching a very simple example (Gh 0.6.0059)
I hope this is helpful,
- Giulio
________________
giulio@mcneel.com
McNeel Europe, Barcelona…
speed.
Iam using a Q6600 Quad (2.4) and 6 gb Ram with a Nvidia 460 GTX (1024) GH runs well on it but with really complex Data it takes a few minutes until u get an result.
U should get a machine with this Hardware for less than 500 Euro. But i would get a faster prozessor.
Greetings…
standard preview color for selection is green).
3. Right-click component which contains data you don't want to see and select "Preview" option.
4. Now you should see only transformed geometry.…
ction) and apply symmetry at some point. The question is when. I would like to operate a "loft with rails", or a "sweep3". It is really important for me to stay perfectly close to the rails (outlines apex), avoiding having a polysurface or more control points. I need advises and help about the logic and order of construction. How should I tackle the problem ? I can't merge a simple symmetry into a single surface. Is it a question of degree (curves or surface) ? Thank you very much. Best Laurent
…
B, as needed). I read lot of topics on forum and as I know it definetely works perfectly in older versions of grasshopper. In recent version is that problem, that´s not possible take data A and make difference with all of the data B. The choice which you mentioned works, but it takes data A and every one item make diference with all data from B - so it makes duplicates with holes on different places (see picture, its from example model from post before, you can try it)
I found 3 possible solutions:
1) C# script (made by S.Schiefer )
2) Python script (made by Ionut Anton)
3) get older version of GH
If am I right, it´s a pitty. Thank you , again
regards
J.…