sing an LFO or (HoopSnake LFO simulator in GH) for wind simulation on the kites... I'll look into that.
Attached are the three remaining presets for anyone else wanting to use an LPD8 (great wee solution) These presets need uploaded to the LPD8 with its editor software.
One thing I have noticed using this method... If I turn the knob rapidly to 0 or 127 the value read in grasshopper often stops reading short of the final number.. e.g. at 3 and 124
Turning the knob slowly gets you the 0 and 127. It may be that there is no final refresh / new data being seen from pure data due to GH PD handshake timing?...
I wonder if there is a way to delay or add an extra packet send after ~0.2 sec quiet in PD? It could be sent after a last data packet leaves PD? hmmm, will investigate if this is a nuisance in use.
Thanks again Mark, really helpful…
say about revit 2017, I hope it will work for revit 2017.
1. Install Chameleon for 2012 following the install instructions.
2. Copy the files in this folder: C:Users*your user name*AppDataRoamingAutodeskRevitAddins2012
3. to this folder: C:Users*your user name*AppDataRoamingAutodeskRevitAddins2013
4. Open Revit…
my device, for example, slowly decays back down to zero when you let go (the decay time can be adjusted). It's cool to watch Grasshopper animate this way. If you have an LFO you could have your device send MIDI values (0 to 127 and back down to 0) and watch the kite flutter. I suppose you could accomplish the same thing just using HoopSnake in GH too.
Cheers.…