the one-but-last list [4]. After running out of the n- items avalaible it should continue with the second item of list 0 and so on for all items on all the lists.
Intput, six lists of 30 items each
[0] (n=30)
[1] (n=30)
[2] (n=30)
[3] (n=30)
[4] (n=30)
[5] (n=30)
Output, 18 lists of 10 items each
[0],i=0;[5],i=4; [4],i=7;...
[0],i=1;[5],i=5; [4],i=8;...
...
[5],i=1;[4],i=5; [3],i=0;...
I thought perhaps the weave component or the relative tree item component but didn't manage to figure out how to compose the mask. I couldn't find much on how to use these. I guess it should wrap the lists, but not the items.
Any help would be greatly appreciated.…
Added by Thorsten Lang at 2:27am on January 24, 2011
en 3 of them, and one poolyline between two of them.
It would also be very nice if i could control it so that only the successive ones can be connected
so if {0:0:0} has 8 points and {0:0:1} has 8, as do {0:0:5} and {0:0:6} i would like to have this as two polylines, not one continoous that would in this case jump three branches (or curves that are shorter).
Does this make any sense?…
Added by Dusan Bosnjak at 2:08pm on September 28, 2009
53 → 53 → 63 → 74 → 74 → 84 → 9
As you can see from the above list the connection sequence comes in waves of three, where each group of similar indices on the left is associated with a group of three incrementing indices on the right.
Some combination of Series components will probably generate this list, but it'll only work for the first ring, the second one will need a different connection pattern. It is perhaps better to just encode the integer pairs by hand. But then you cannot change your mind about the number of sides later.…
Added by David Rutten at 10:39am on October 21, 2015
a follow up question... how do I wrap a list onto itself at a certain frequency?
i.e. I want the list {1;2;3;4;5;6;7;8;9}
to become {1,4,7; 2,6,8; 3,6,9} wrapped every 3rd item
Added by Joshua Jordan at 5:30pm on November 17, 2012
of the panel in the middle (See attached picture 1). When exploding another panel, the command explodes the curve into 7 segments (See attached picture 2).
Is there a solution so that the explode command explodes the curve in just 4 edges, so that I can use the 4 edge curves as input for a surface from 4 edge curves?
I tried the Patch command, but this command will not give the right curvature of the surface, so I need the surface from 4 edge curves command.
Does anyone have any suggestions?
Thnx!!
…