should not be open).
3. All releases of Rhino 5, Arduino, GH, and FF are the latest as of May 21st.
I Boolean toggled the port open, but I can't seem to get any output to display from the UnoRead component. I was hoping to see values from any of the analog inputs (APin5 depicted) connected as info gets sent back and forth between the Arduino and my comp. I'm getting simultaneous "Hooray" and "Whoops" messages, and I can't pinpoint why. See attached JPG.
Does it have to do with the fact that I have a list of COM ports? Even though I know COM 3 is the correct one as defined in the IDE, do I need to re-declare it in Grasshopper as well? Does the {0} shown impact this output?
Any direction is appreciated.
Thanks - JFig
…
e! I do not have good ideas today!
The end result of the list would be:
5, 10, 15, 20, 21, (21 + 5), (21 + 10), (21 + 15), (21 + 20), (21 + 21), (42 + 5), (42 + 10), (42 + 15), (42 + 20), (42 + 21), etc …
cture, Rhino treats them as a single flat list. For example a surface can have 10 rows and 6 columns of control-points, resulting in a list of 60 points.
But 10 times 6 isn't the only way to get to 60. If you want to make a surface out of a list of 60 points, you'll also have to tell Rhino how those 60 points should be interpreted in terms of a grid. It could be 2*30, 3*20, 4*15, 5*12, 6*10, and all of the aforementioned products the other way around.
Sometimes there's only one way for a number of points to fit into a rectangular grid. For example if you provide 49 points, then 7*7 is the only way to make it work, but these cases are rare so we always demand you give us all the information required to actually make a rectangular grid of control-points from a linear collection.
As for "Why is it, sometimes we need to attach additional value into it?", this is usually because when you divide a domain or a curve into N segments, you end up with N+1 points. For example take the domain {0 to 5}, and divide it into 5 equal subdomains. You end up with {0 to 1}, {1 to 2}, {2 to 3}, {3 to 4} and {4 to 5}. However there are six numbers that mark the transitions between these domains 0, 1, 2, 3, 4 and 5. This is why you often have to add 1 to the UCount, because the number that controls the UCount often results in N+1 actual points.…
Added by David Rutten at 8:30am on December 25, 2014
r itself is compiled against .NET 3·5.
I recommend you use Rhino4, .NET 3·5 and VS 2008 as a debugging platform.
--
David Rutten
david@mcneel.com
Poprad, Slovakia…