ee 3)
{5}
0 15
{6}
0 16
And I want to place points at every possible combination of these coordinates, treating Tree 1 as X coordinates, Tree 2 as Y coordinates, and Tree 3 as Z coordinates. Also, I would like the list of points to be a tree with paths corresponding to the coordinates. Wouldn't it be nice if I could plug these trees into a Point XYZ, with a new "branch cross reference" method, and get the following result?
{0:3:5}
0 {10.0, 13.0, 15.0}
{0:3:6}
0 {10.0, 13.0, 16.0}
{0:4:5}
0 {10.0, 14.0, 15.0}
{0:4:6}
0 {10.0, 14.0, 16.0}
{1:3:5}
0 {11.0, 13.0, 15.0}
{1:3:6}
0 {11.0, 13.0, 16.0}
{1:4:5}
0 {11.0, 14.0, 15.0}
{1:4:6}
0 {11.0, 14.0, 16.0}
{2:3:5}
0 {12.0, 13.0, 15.0}
{2:3:6}
0 {12.0, 13.0, 16.0}
{2:4:5}
0 {12.0, 14.0, 15.0}
{2:4:6}
0 {12.0, 14.0, 16.0}
In this form of cross referencing, every combination of individual branches from the different lists is used as separate input, and the output for each combination is put onto a branch in the result whose path is the concatenation of the input branch paths used.…
Added by Andy Edwards at 7:03pm on November 3, 2009
lute_extrudersteps = 1
xbar_heightfromnozzletip = 30
xbar_width = 30
If you add these to your config file (and adjust appropriately) it should work fine. In future there may be more additions to the config file as we try and take into account the way other firmware interprets g-code, but these will be listed in the release notes.
…
then the time is 02:00...when it is 23 the the time is 23:00, but then when it is 49 then it is 01:00 of the next day...any idea?
thx in advance!
Nassif…
should not be open).
3. All releases of Rhino 5, Arduino, GH, and FF are the latest as of May 21st.
I Boolean toggled the port open, but I can't seem to get any output to display from the UnoRead component. I was hoping to see values from any of the analog inputs (APin5 depicted) connected as info gets sent back and forth between the Arduino and my comp. I'm getting simultaneous "Hooray" and "Whoops" messages, and I can't pinpoint why. See attached JPG.
Does it have to do with the fact that I have a list of COM ports? Even though I know COM 3 is the correct one as defined in the IDE, do I need to re-declare it in Grasshopper as well? Does the {0} shown impact this output?
Any direction is appreciated.
Thanks - JFig
…
cotains 5 data. if the "y" is 3, the a is 34 branch ,the branch in 1 to 33,contains 3 data,and the 34th branch contains 1 data.. i dont know how to write the python code.…