EC
1. Between hours 1:00 to 24:002. Current document units is in Meters3. Conversion to Meters will be applied = 1.0004. [1 of 7] Writing simulation parameters...5. [2 of 6] No context surfaces...6. [3 of 6] Writing geometry...7. [4 of 6] Writing materials and constructions...8. [5 of 7] Writing schedules...9. [6 of 7] Writing loads and ideal air system...10. [7 of 7] Writing outputs...11. ...... idf file is successfully written to : c:\ladybug\Freeformtower_IDF\EnergyPlus\Freeformtower_IDF.idf12. 13. Analysis is running!...14. ......
Done! Read below for errors and warnings:
15. 16. Program Version,EnergyPlus-Windows-64 8.1.0.009, YMD=2015.04.04 23:39,IDD_Version 8.1.0.00917. 18. ************* IDF Context for following error/warning message:19. 20. ************* Note -- lines truncated at 300 characters, if necessary...21. 22. ************* 577 Zone,23. 24. ************* Only last 1 lines before error line shown.....25. 26. ************* 578 Freeformbuilding27. 28. ** Warning ** IP: IDF line~578 Comma being inserted after:" Freeformbuilding" in Object=ZONE29. 30. ** Severe ** Out of range value Numeric Field#5 (Type), value=0.00000, range={>=1 and <=1}, in ZONE=FREEFORMBUILDING31. 32. ************* IDF Context for following error/warning message:33. 34. ************* Note -- lines truncated at 300 characters, if necessary...35. 36. ************* 586 BuildingSurface:Detailed,7341.
…
onsecutive points at the same height then your 'Break at discontinuities' component eliminates the middle point completely and then the 'Interpolate Curve' component gives a much bigger bump in the wrong direction. This was enough to get curves to meet from opposite sides.
I fixed this by changing the heights to 1.1 or 2.9, rather than 1.0 and 3.0, but it took a little while to work it out! Sigh.
I attach a new version. But I actually preferred it as it was before. See what you think!
Bob
p.s. in the first list, elements 11, 12, 23 and 24 go from 1 to 3; elements 17 and 18 go from 3 to 1. In the second list, elements 6, 17, 18 and 29 go from 1 to 3; elements 12 and 23 go from 3 to 1. Given the above fix, these can be easily seen.…
Added by Bob Mackay at 10:40pm on November 24, 2015