say about revit 2017, I hope it will work for revit 2017.
1. Install Chameleon for 2012 following the install instructions.
2. Copy the files in this folder: C:Users*your user name*AppDataRoamingAutodeskRevitAddins2012
3. to this folder: C:Users*your user name*AppDataRoamingAutodeskRevitAddins2013
4. Open Revit…
ison, construct a 15' long plywood bench for Mark Weston's Digital Fabrication Studio, Spring 2013.
Rhino and Grasshopper were used to design the bench parametrically in 3D. The model was then contoured in the computer to generate 129 sections. Each section was cut out using a 3 Axis CNC Router. 520 spacers separate each contour by 3/4" to make the bench's total length. 3/8" all-thread rod runs through each segment of the bench. When tightened, the rods put the plywood pieces in compression, holding each section together without glue.
We estimate apprx. 200 man-hours went into this project over the course of less than a week. The project contains 129 contour pieces, 520 spacers, roughly 120 feet of threaded rod, 40 nuts, 40 flat washers, 40 lock washers, and 2.5 gallons of waterproof sealer.…
- valence 3 junctures whose incident edges form 120 degree angles.
The video above shows 20k particles navigating a periodic 64x64x64 voxel grid at approximately 20 fps.…
Added by David Reeves at 1:54am on September 20, 2014
ee red lines with an angle in plan (XY) of 120° between each other
3) In axo view, you see that they are 33.6° between each other (considered the plan composed by two lines), but still 120° in XY of course (it's just a different view, not different drawing). This is a fxxxng random angle, just an example.
now...
4) I wish to decide which is the angle and I want to have, for example, 39° instead 33.6, but I want to KEEP 120° in XY.
It means that the red lines will go a little bit down. Try to imagine an umbrella that is going to open... ahaha forget the umbrella please! (you know what I mean)
5) HOW TO DRAW THESE FXXXNG LINES?
I appreciate a lot :D
…