A low-resolution work. Real time motion capture display made with an 11x8 (88) pixels iPad matrix using Grasshopper + Firefly + Pure Data + TouchOSC for iPad.
a working solution with replacing this line of code with:
Dim charList As New List(Of Char)(charArr)
Is this because of a version incompatibility (I'm using Rhino 4.0, and GH 0.8.0062)? Just curious.
Regards,
JJ…
ce?) (line 86)""Error: 'Rhino.DocObjects.Tables.LightTable' does not contain a definition for 'Sun' (line 86)"
I'm using Rhinoceros 4.0 v9 and just recently installed the Rhino4.0SDK. Any comments/suggestions would be appreciated. Thanks …
f the mesh was self-intersecting everywhere. So instead I used Millipede (isosurface) to get the same undulations, but ignore the complex 'folds', you can see the difference in cross section thickness. I then tessellated it with the inverse pattern of the outer surface.
To make it a single 3d printable mesh, i just deleted a single face on inner and outer skin, then lofted the naked edges. (creating a tiny hole through the model). Therefore creating a single mesh that folds in on itself, not sure if there is a better way of defining the space between two meshes as the solid area...
Full GH (Kangaroo - Meshmachine - Weaverbird - Millipede)
Special thanks to Laurent Delrieu for his interesting offset mesh method that i based my approach on.
http://www.grasshopper3d.com/forum/topics/offset-mesh-problems-with-3d-mesh-with-weaverbird…
Added by Nick Tyrer at 5:25am on December 10, 2015
Hey, you need to reparameterize the Srf. You're running into the problem described on p. 86 in the primer, where you need to reset the domain of the surface to be between 0 and 1 :)
g these times itself). If it works on selection alone, it would probably implement faster.
Theoretically, does this mean the total solving time of the definition is the 'chain of components' that takes the longest time? In the picture above, it would be the chain consisting 'point-curve-divideDistance'?
Because that still adds up only to 97%, I am assuming the Point and Slider component start solving in parallel, and the two Divide components also start solving in parallel?…