I have a database with about 80 tables on it, so i wanna connect to the database, make 5/6 different queries, extract the info and use it as an input to grasshopper.
a working solution with replacing this line of code with:
Dim charList As New List(Of Char)(charArr)
Is this because of a version incompatibility (I'm using Rhino 4.0, and GH 0.8.0062)? Just curious.
Regards,
JJ…
f the mesh was self-intersecting everywhere. So instead I used Millipede (isosurface) to get the same undulations, but ignore the complex 'folds', you can see the difference in cross section thickness. I then tessellated it with the inverse pattern of the outer surface.
To make it a single 3d printable mesh, i just deleted a single face on inner and outer skin, then lofted the naked edges. (creating a tiny hole through the model). Therefore creating a single mesh that folds in on itself, not sure if there is a better way of defining the space between two meshes as the solid area...
Full GH (Kangaroo - Meshmachine - Weaverbird - Millipede)
Special thanks to Laurent Delrieu for his interesting offset mesh method that i based my approach on.
http://www.grasshopper3d.com/forum/topics/offset-mesh-problems-with-3d-mesh-with-weaverbird…
Added by Nick Tyrer at 5:25am on December 10, 2015
omponent that increases in the x-axis (example below).
A1 A2 A3 A4 A5 etc...B1 B2 B3 B4 B5 etc...C1 C2 C3 C4 C5 etc...D1 D2 D3 D4 D5 etc...
This is as far as I've gotten:
I have collected my points on the grid into a "List Length" component and input that into a "Series" which input into a "Function" with the expression Format("A{0}",x). The result labeling resembles the example below.
A1 A2 A3 A4 A5
A6 A7 A8 A9 A10
A11 A12 A13 A14 A15 etc...
Any help is appreciated.
Thank you in advance.…
urs x 365 days ), and with modulus in the screenshot above, i could manage to do for every hour. but sometimes in my definition, i have a range from 1 to 35040, which is 365 x 24 x 4 ( 4 here defines every 15 minutes), on other word, when the number is one, then i have 01:00 O'Clock, when the number is 2 then i have 01:15 O'clock, when the number is 3 then i have 01:30 O'Clock...etc , so when the number is 97, which is the next day ( and after the number 96 which is equal 24 hours x 4), then I should have again 01:00 O'Clock.
I hope my idea is clear, thanks in advance!
Nassif…
g these times itself). If it works on selection alone, it would probably implement faster.
Theoretically, does this mean the total solving time of the definition is the 'chain of components' that takes the longest time? In the picture above, it would be the chain consisting 'point-curve-divideDistance'?
Because that still adds up only to 97%, I am assuming the Point and Slider component start solving in parallel, and the two Divide components also start solving in parallel?…
e. I want to be able to give it the panels a range let say between 1-3 and then give it a specific number of variations allowed, like only 80 different heights can be generated and the rest of the panels would be rounded up or down to match with one of the 80 heights. would that be possible?
Thanks…