urs x 365 days ), and with modulus in the screenshot above, i could manage to do for every hour. but sometimes in my definition, i have a range from 1 to 35040, which is 365 x 24 x 4 ( 4 here defines every 15 minutes), on other word, when the number is one, then i have 01:00 O'Clock, when the number is 2 then i have 01:15 O'clock, when the number is 3 then i have 01:30 O'Clock...etc , so when the number is 97, which is the next day ( and after the number 96 which is equal 24 hours x 4), then I should have again 01:00 O'Clock.
I hope my idea is clear, thanks in advance!
Nassif…
a working solution with replacing this line of code with:
Dim charList As New List(Of Char)(charArr)
Is this because of a version incompatibility (I'm using Rhino 4.0, and GH 0.8.0062)? Just curious.
Regards,
JJ…
f the mesh was self-intersecting everywhere. So instead I used Millipede (isosurface) to get the same undulations, but ignore the complex 'folds', you can see the difference in cross section thickness. I then tessellated it with the inverse pattern of the outer surface.
To make it a single 3d printable mesh, i just deleted a single face on inner and outer skin, then lofted the naked edges. (creating a tiny hole through the model). Therefore creating a single mesh that folds in on itself, not sure if there is a better way of defining the space between two meshes as the solid area...
Full GH (Kangaroo - Meshmachine - Weaverbird - Millipede)
Special thanks to Laurent Delrieu for his interesting offset mesh method that i based my approach on.
http://www.grasshopper3d.com/forum/topics/offset-mesh-problems-with-3d-mesh-with-weaverbird…
Added by Nick Tyrer at 5:25am on December 10, 2015