rface(test_brep, test_surface, 0.1, curves_list, points_list)
and I get back:
1. Error (BC30311): Value of type 'System.Collections.Generic.List(Of Rhino.Geometry.Curve)' cannot be converted to '1-dimensional array of Rhino.Geometry.Curve'. (line 97)
2. Error (BC30311): Value of type 'System.Collections.Generic.List(Of Rhino.Geometry.Point3d)' cannot be converted to '1-dimensional array of Rhino.Geometry.Point3d'. (line 97)
Could anyone tell me what I'm doing wrong?
Thanks!…
, a1200)}) Is there any way I can make this list into {a1, a2, a3, a4, -a5, -a6, -a7, -a8, a9, a10, a11, a12, -a13, ..... , a1200} ? ( 4 positive signs then 4 negative signs and so on) - alternating every nth in general.
or
2. Is there any way (workaround) to get negative angle value from 2 vectors? I know 'ANGLE (of 2 vectors)' component by itself doesn't work and I know why too. I have feeling that the reflex angle output might be useful but again, matter of list manipulation.
Any help would be greatly appreciated. Thanks in advance.
Hyo
…
e. I want to be able to give it the panels a range let say between 1-3 and then give it a specific number of variations allowed, like only 80 different heights can be generated and the rest of the panels would be rounded up or down to match with one of the 80 heights. would that be possible?
Thanks…
ven if the number of panels inside each cell varies. The current solution works when the number of panels inside each cell is always two or other same numbers, but it wouldn't work if the number of panels inside frames are different in each cell. It would be perfect, if numbering of panels are automatically added correctly next to the cell number based on the number of panel division instead of feeding the fixed number.
To take an example, let's assume that the cell #80 has three panels and the #81 has two ones. In this case, three panels within the cell #80 would be numbered like 80-1, 80-2, 80-3, while two panels within the #81 would be numbered such as 81-1 and 81-2 automatically. …
rotate back to zero degree (start position) then don't rotate, then rotate to -80 degree, then back to zero degree (start position) and stay there.
I hope the you can help me.
Thank you.
…