0.533000void brightfunc skyfunc2 skybright perezlum.cal010 1.382e+00 3.201e-01 1.066879 -0.754821 0.015485 -0.048998 -0.089403 0.066341 -0.860010 0.505947
The values in bold are then evaluated using the equations in the file perezlum.cal inside the RAYPATH directory in Radiance..
{ All-weather Angular Sky Luminance Distribution . Additional arguments required for calculation of skybright: A1 - diffus normalization A2 - ground brightness A3,A4,A5,A6,A7 - coefficients for the Perez model A8,A9,A10 - sun direction}skybright = wmean((Dz+1.01)^10, intersky, (Dz+1.01)^-10, A2 );wmean(a, x, b, y) = (a*x+b*y)/(a+b);intersky = if( (Dz-0.01), A1 * (1 + A3*Exp(A4/Dz) ) * ( 1 + A5*Exp(A6*gamma) + A7*cos(gamma)*cos(gamma) ), A1 * (1 + A3*Exp(A4/0.01) ) * ( 1 + A5*Exp(A6*gamma) + A7*cos(gamma)*cos(gamma) ) );
This data is then mapped to the "glow" material that represents the celestial hemisphere...You can edit the climate based sky produced by Honeybee and enter your own values. The other option would be to just use gendaylit from DOS Prompt.…
xtract A1, A2, B1, B2 as one set, A2, A3, B2, B3 as the second set, A3, A4, B3, B4...etc. as the third set and so on. How can I get about doing this?
Any help would be much appreciated!
Thanks,
Ben…
ide into 80 branches, and 80 outputs of explode and 80 dispatches - its my nightmare. Is there any way to do this with parametric Number of brunches? …
a working solution with replacing this line of code with:
Dim charList As New List(Of Char)(charArr)
Is this because of a version incompatibility (I'm using Rhino 4.0, and GH 0.8.0062)? Just curious.
Regards,
JJ…
f the mesh was self-intersecting everywhere. So instead I used Millipede (isosurface) to get the same undulations, but ignore the complex 'folds', you can see the difference in cross section thickness. I then tessellated it with the inverse pattern of the outer surface.
To make it a single 3d printable mesh, i just deleted a single face on inner and outer skin, then lofted the naked edges. (creating a tiny hole through the model). Therefore creating a single mesh that folds in on itself, not sure if there is a better way of defining the space between two meshes as the solid area...
Full GH (Kangaroo - Meshmachine - Weaverbird - Millipede)
Special thanks to Laurent Delrieu for his interesting offset mesh method that i based my approach on.
http://www.grasshopper3d.com/forum/topics/offset-mesh-problems-with-3d-mesh-with-weaverbird…
Added by Nick Tyrer at 5:25am on December 10, 2015