a working solution with replacing this line of code with:
Dim charList As New List(Of Char)(charArr)
Is this because of a version incompatibility (I'm using Rhino 4.0, and GH 0.8.0062)? Just curious.
Regards,
JJ…
f the mesh was self-intersecting everywhere. So instead I used Millipede (isosurface) to get the same undulations, but ignore the complex 'folds', you can see the difference in cross section thickness. I then tessellated it with the inverse pattern of the outer surface.
To make it a single 3d printable mesh, i just deleted a single face on inner and outer skin, then lofted the naked edges. (creating a tiny hole through the model). Therefore creating a single mesh that folds in on itself, not sure if there is a better way of defining the space between two meshes as the solid area...
Full GH (Kangaroo - Meshmachine - Weaverbird - Millipede)
Special thanks to Laurent Delrieu for his interesting offset mesh method that i based my approach on.
http://www.grasshopper3d.com/forum/topics/offset-mesh-problems-with-3d-mesh-with-weaverbird…
Added by Nick Tyrer at 5:25am on December 10, 2015
g these times itself). If it works on selection alone, it would probably implement faster.
Theoretically, does this mean the total solving time of the definition is the 'chain of components' that takes the longest time? In the picture above, it would be the chain consisting 'point-curve-divideDistance'?
Because that still adds up only to 97%, I am assuming the Point and Slider component start solving in parallel, and the two Divide components also start solving in parallel?…
closest point to the very first would be removed from the list, so the initial list reduces from 100 to 98. From the 98 i pick one and search the remaining 97 for the closest. From the remaining 96 i pick again one and search in the 95,...
(The product I want to result is:
having a number of random lines in 3D space, produced by an even number of points as discribed, this shall be the initial springs for a ("selfadjusting") tensegrity. Each one of these lines (later springs in kangaroo) get divided in three areas - that means four points. These four points again are the "attractor points" of neighbor springs, so the strut "knows" where to set the next elastic connection,...the rest I´ll have to figure out)
angelos…
. The rules to dispatch the lines are the next:
I start with a list that alternate true/false; like that: true, false, true, false.
If the angles between those lines are greater than 89° I want to inverse the next part of the list:
True, False, True, False, True, False,...
become
True, False, [>89°] False, True, False, True, [>89°] True, False,...
I managed to create a true false list, to check for the greater than 89° angle, to separate the lines relatively to the angles, but I don't know how to inverse part of the list at certain index.
(In the picture, I have written 90° but it should be 89°, I check for greater than 89° and not equal to 90° because in the real rhino model, the lines won't be exactly orthogonal)
If you have another idea to to reach the same result, it's also okay, I tried to find rules to solve the problems, but I may have overlooked other solutions !
And if there is some part of the patch that are correct but there is easier solution, I would love to learn as I am still new to grasshopper.
Thanks for taking the time to read. :)
…