of lines, etc) but I can't see a way to add the text I need where I need it. If I could get each line for the print run to generate automatically, I can put the rest in manually, so just need something like:
... ; I would do the previous to this manuallyG1 X10 Y5 Z3
G1 X5 Y5 E5
G1 X5 Y15 E10
... ; I would do the rest manually
for a 5 mm line from [10, 5, 3] to [5, 5, 3], followed by a 10mm line from there to [5, 15, 3]. Any pointers greatly appreciated.
Ewan…
moved by random amounts in a random direction. The animated slider was the amount of deviation from the original points. And yes, I used culled lists.B.t.w. did you find my workaround for your loft? Did your notebook explode? ;)…
est of the best)
Crucial DDR4 2133 ECC (what else?)
4* WD RE 500 in Raid combo (not shown)
Some stupid 2.5'' HD thingy (avoid 2.5'' disks)
No SSD thingy
Corsair CPU cooler (Tequila replaced the OEM liquid: it works)
…
a working solution with replacing this line of code with:
Dim charList As New List(Of Char)(charArr)
Is this because of a version incompatibility (I'm using Rhino 4.0, and GH 0.8.0062)? Just curious.
Regards,
JJ…
f the mesh was self-intersecting everywhere. So instead I used Millipede (isosurface) to get the same undulations, but ignore the complex 'folds', you can see the difference in cross section thickness. I then tessellated it with the inverse pattern of the outer surface.
To make it a single 3d printable mesh, i just deleted a single face on inner and outer skin, then lofted the naked edges. (creating a tiny hole through the model). Therefore creating a single mesh that folds in on itself, not sure if there is a better way of defining the space between two meshes as the solid area...
Full GH (Kangaroo - Meshmachine - Weaverbird - Millipede)
Special thanks to Laurent Delrieu for his interesting offset mesh method that i based my approach on.
http://www.grasshopper3d.com/forum/topics/offset-mesh-problems-with-3d-mesh-with-weaverbird…
Added by Nick Tyrer at 5:25am on December 10, 2015