algorithmic modeling for Rhino

Springs from lines generated by Grasshopper

My simulation is quite simple : just a bunch of straight lines connected to each other and used as springs.

When I generate those lines within Grasshopper, the simulation seems to run on twice the springs that were input, resulting in something quite different as expected.

But if I input these lines from existing Rhino lines, then the simulation runs fine with just the set of springs that were input.

Am I missing something, or is this a known limitation of Kangaroo ?

Cheers,

Olivier

Replies to This Discussion

Permalink Reply by Olivier Suire on August 4, 2012 at 6:06am

It appears that the duplication of springs is due to the fact I have two anchor points.

In fact, with only one anchor points, the simulation uses only the springs that I input but if I add a second anchor point, then Kangaroo duplicates the springs...

See here : https://www.box.com/shared/static/7a8043333c601eefad57.avi

Cheers,

Olivier

Permalink Reply by Anders Holden Deleuran on August 6, 2012 at 5:47am

Try to flatten the anchor points input. Should do the trick..

Permalink Reply by Michael Fluer 14 hours ago

G’day, I was scrolling through a gaming forum after dinner looking for a new casino site to try. In the middle of one conversation someone mentioned sweety spin so I decided to give it a chance. I started with Gates of Olympus but had a run of unlucky spins. After increasing my stake slightly, the multiplier feature finally landed and the win was surprisingly good. That turnaround made the session much more exciting than I expected.

RSS