Grasshopper

algorithmic modeling for Rhino

Kangaroo Discussions (827)

← Back to Kangaroo
Discussions Replies Latest Activity

vertical wooly paths HELP

  I'm trying to create attractions between paths, I think it is because Im a beginner in kangaroo/grasshopper, but Im getting an error in a…

Started by JORGE LUIS TREVIÑO GARZA

1 Feb 28, 2011
Reply by Christoph Degendorfer

distorted catenary by one point-mass (specific load)

hi all,   i´m trying to achieve a simply distorted catenary, adding mass to a specific point of the catenary. The problem is that when the…

Started by j.j. sendra

5 Feb 25, 2011
Reply by Vicente Soler

Arduino, FireFly + Kangaroo, why do I get this error? SOLVED

Hi! I'm moving a Kangaroo anchor point with a slider (x value) and it's working fine. When I replace the slider with values from FireFly (A…

Started by Mårten Nettelbladt

1 Feb 23, 2011
Reply by Mårten Nettelbladt

Deformable human

definition attached below :)

Started by Daniel Piker

5 Feb 20, 2011
Reply by Chris Wilkins

Evil Empire

FYI, from the "A" word...   http://labs.autodesk.com/utilities/nucleus/

Started by taz

2 Feb 14, 2011
Reply by robert cervellione

Conform Curves

Hi,  I have been trying to create a simple interaction in Kangaroo where a circle would collapse around a series of arbitrary lines or clos…

Started by Glenn Edwards

7 Feb 11, 2011
Reply by Glenn Edwards

Rigid frames

Hello, Often when I'm trying create some model, i want to have rigid elements. But when i use very high stiffness springs (over 1e7 for exa…

Started by Danijel Ivanusevic

1 Feb 11, 2011
Reply by Daniel Piker

Fishing rod

Hi,   Im trying to make a fishing rod, a flexible line that bends when you put some weight at the end.   I have read the basic kangaroo man…

Started by gonzalo

4 Feb 8, 2011
Reply by gonzalo

Geometry confusion

HI, I'm new to Kangaroo and trying to model something similar to a sushi mat: a set of linear elements woven together into a mat. Then that…

Started by Dave Johnson

4 Feb 4, 2011
Reply by Dave Johnson

pressure modulation / equalization

exciting work here. just installed kangaroo. was wondering if anyone out there was working on a similar problem to the one i'm figuring to…

Started by seth wiley

1 Jan 29, 2011
Reply by Daniel Piker

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2019   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service