Grasshopper

algorithmic modeling for Rhino

Hi everyone,

I have been playing around peacock for a while and it's a awesome tool for jewelry design.

Recently I had a problem with the tool of "prongs along gems rails". I want the width of prongs between the gems will be adjusted or changed by the room between gems. Now the prongs just keep the same width along the gems.  Anyone knows how to figure out? Thanks! See the screenshot below:

Views: 1102

Replies to This Discussion

Hey, I don't know why I missed this thread, sorry!

Sure you can, just plug a list of values for the width, and the component will interpolate them.

you can also make it relative to the size of the gems, taking their size, calculating the average value between one and the next, and remapping those values to a domain that is valid for the size of the prongs.

There would be other ways, but basically you just need to give him a list of values.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service