Decompose based on boundary condition is not decomposing

Replies to This Discussion

Permalink Reply by Anton Szilasi on January 26, 2016 at 9:23am

 

Khandaker,

You were using an old version of Honeybee Honeybee it should work fine now. See attached. Be sure to always update your components using the component Honeybee_Update Honeybee.

Attachments:

• MackeyResidenceGeometryAdajacies AJZ.gh, 478 KB

Permalink Reply by Khandaker Rasel Kabir on January 27, 2016 at 6:22pm

Thank you Anton. I tried to update ladybug and Honeybee it worked at first but after that this update is not working anymore.Can you please also help in one of my file where energy plus simulation is not working. I am not getting any idf file or simulation result. I have attached my file.

Attachments:

• 6 - Running a Basic Energy Simulation by krk.gh, 511 KB

Permalink Reply by Tim on January 27, 2016 at 10:45pm

I'd suggest to plug the toggle to _UpdateThisFile to update only what you work on.

Occasionally you would have to change some of the updated components by dragging them from the LB/HB panels.