Grasshopper

algorithmic modeling for Rhino

stiffness explosion

Hi all

I am using mesh relaxation for a model where diffeernt areas, of the mesh are more relaxed than other areas. I have decided the best way is to use cable ties and vary the stiffness of these which would then make have an effect on the mesh. Only problem is I cant seem to change the stiffness anymore (the cables to be larger than 5000 and the mesh lower than 400) without it exploding.. any ideas please?
 

Views: 335

Replies to This Discussion

Permalink Reply by Daniel Piker on November 28, 2011 at 3:03pm

Hi Megan,

Generally whenever the simulation is exploding (which will happen with certain combinations of spring stiffness) you can fix it by lowering the timestep.

Try changing it from 0.01 to 0.005 or 0.001

This will slow things down slightly but it should make it stable.

You can increase the speed a bit by upping the value of SubIterations, so it calculates more physics cycles in between drawing to screen.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service