Grasshopper

algorithmic modeling for Rhino

Starting up in Kangaroo

Hi,

 

I am starting to experiment with line bending in Kangaroo and I need some help with learning how to bend a line, anchoring one end of a line and bending the other, etc. Does anyone have any advice?

Views: 271

Replies to This Discussion

Permalink Reply by Victor Leung on October 9, 2011 at 3:52am

If you have a line, divided to many segments.

Anchor the first two points. Apply bending resistance to all other points (eg: pt1,2,3 then pt2,3,4...)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

Switch to the Mobile Optimized View

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service