Grasshopper

algorithmic modeling for Rhino

The Generation plug-in looks very good.   I have been using it for nesting.  The nesting can take a long time.  When I get less patient I start changing sliders as it is calculating, this will crash Rhino.  Is there a way to stop the nesting from calculating until I tell it to?  Does the nesting component need a On/Off switch?

Views: 874

Replies to This Discussion

Hi Scott,

thanks for your appreciation!

The GENERATION components are not the "doubleclicktorun" type.

Grasshopper Data Buffer could be useful to avoid the crash.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

© 2019   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service