Grasshopper

algorithmic modeling for Rhino

ZIG-ZAG LOFTING

Hi All,

I'm trying to loft (straight sections) between two set of curves. Ideally, I would like to achieve something like this:

However, my definition is lofting through all the curves in one blow, producing warped inside-out geometry:

I understand why its doing it but I can't troubleshoot it.

Views: 1073

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on September 2, 2016 at 1:05am

Something like this?

Attachments:
Permalink Reply by Danny Le on September 2, 2016 at 5:28am

Yep! You're the man Hyungsoo Kim!

I'm going to now attempt to loft using an "X" pattern. I assume its  basically the same definition except the cull pattern is reversed?

Permalink Reply by Hyungsoo Kim on September 2, 2016 at 5:40am

Please review details carefully before continuing.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service