Grasshopper

algorithmic modeling for Rhino

Wish PullPointstoFace on Rhino4

Hi,

I've just noticed that Rhino.Geometry.BrepFace.PullPointsToFace Method is available in the VB component of Rhino5 WIP. But not in Rhino4.

I would like to request this method in the VB(and C#) component in Rhino4.

According to this post from Dale I think I can write similar function by hand, but it would be better if I could use same PullPointsToFace method on both V4 and V5, to keep code simpler.

Thank you,

--

Taka

 

: edited for wrong link

Views: 164

Replies to This Discussion

Permalink Reply by David Rutten on July 25, 2011 at 4:42am

Hi Taka,

 

if you can give me some C#/VB code that will run on the R4 SDK and does exactly the same thing as the PullPointsToFace function I can put it in RhinoCommon.

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by T. YAGI on July 25, 2011 at 9:46am

Thank you David !

I tried to make small VB code that mimic PullPointsToFace (not exactly the same though...) and sent you as a message.

Cheers,

--

Taka

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service