Grasshopper

algorithmic modeling for Rhino

weird output for simple operation in grasshopper for rhino 5.0

hi, everyone!

i've been using grasshopper for a while but i have never seen this: i simply divided a surface using isotrim component and the resulting surface is bigger than the original one...

does anybody know waht's going on?

thanks in advance.

Views: 247

Replies to This Discussion

Permalink Reply by Danny Boyes on June 19, 2013 at 2:09pm

Can you give us a little more to go on?

Is the surface you are using a trimmed surface to start with?

Have you reparameterised it? I.e. Changed the domain from 0-1?

is the subdomain you are supplying for the iso trim larger than the domain of the surface?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service