Grasshopper

algorithmic modeling for Rhino

Voronoi help

Hello all,

 

Can anyone help me on figuring out how can i populate the surface with the all the voronoi cells i created. ( see files) it seems that when i do it the voronoi goes out of scale.

 

thank you in advance.

 

Best

Juan Perez

Views: 418

Attachments:

Replies to This Discussion

Permalink Reply by Jissi Choi on December 5, 2011 at 11:48pm

Because the target surface is not an untrimmed surface..

The Surface Morph component uses an untrimmed (original) surface in morphing.

So, you need an untrimmed target surface.

Permalink Reply by Jissi Choi on December 6, 2011 at 2:09am

I made an untrimmed surface.. from your original surface..

But the edges of the original surface are too winding to avoid overlaps..

 

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service