Grasshopper

algorithmic modeling for Rhino

hi, I'm new to grasshopper. I'm trying a flat surface with Voronoi and I can not close the vertices when using offset.
look at the image

thank you very much for any help!

regards

Views: 1272

Replies to This Discussion

Definition, sorry

Hi isPlaNo,

in your case the Offset goes to the outside of the cells.

But I think you want to have it in the inside.

For this just input a negative number in D.

There are many solutions to do this.

Right click on the D input of the Offset Component and go to expression and write there -D, then the Slider value get's the opposite value

or take the Negative Component from the Math tab to negate the slider value

or just edit the slider from a negative number to 0 or -1 or something else, this depends on you.

Hope this helps.

Best,

Martin.

genius! thank you very much for the help!

try 1000 things and could not do it!

I appreciate your help

Like this

thank

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service