Grasshopper

algorithmic modeling for Rhino

Use of Standard Grasshopper Components Within Custom Code

Hello,

I am developing a custom component where one of the intermediary steps in the calculation could be performed by calling a few grasshopper components in turn.

I realise that this could likely be acheived by using Rhino Common commands, but there is a sufficient number of corner cases and error checking that it would be great if I could stand on the shoulders of David's hard work.

The components I am interested in are:

  • Intersect>Shape>Intersect Region
  • Surface>Freeform>Planar Srf
  • Surface>Analysis>Area

Any information on how to access them would be greatly appreciated!

Hugh

Views: 1024

Replies to This Discussion

Permalink Reply by Giulio Piacentino on November 19, 2013 at 9:00am

Hi Hugh

sorry we did not get back to you earlier. It's hard to spot old, reawakened discussions. It's usually much better to start a new one.

Do you have an example for this error?

Thanks,

Giulio
--

Giulio Piacentino
for Robert McNeel & Associates
giulio@mcneel.com

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service